get in touch

If you would like us to phone you please fill in below:
* Required





Mahogany


Get a quote for a Mahogany worktop


Price per Square Meter


£ 499 - 20mm thick

£ 630 - 30mm thick





Choose your worktop thickness
20mm 30mm

Please enter your worktop sizes
Measure the length (mm) and width (mm) of each worktop piece, breakfast bar and island unit and input them individually into the boxes.

Please note All lengths over 3 metres will be jointed.The positions of the joints will be agreed with the client at the time of templating.

All Worktops come with a complimentary chopping board in the same granite as your worktops

 
Length mm
Width mm
Example
1550
610
Worktop1
Worktop2
Worktop3
Worktop4
Worktop5
Worktop6




Edging
The edges of the worktops that are visible require polishing, a number of different profiles can be applied to these edges, ranging from Single Pencil Arris to Full Bullnose





Double Pencil Round, the most popular and economic edging, can also be made as a single (upper edge only) profile.


Chamfered Edging, another popular profile which again can be supplied as single or double.

Half Bullnose, a stylish and contemporary profile

Full Bullnose, top of the range, sleek round profile

Ogee Edging, a traditional favourite


Please enter your upstand sizes
Upstands are used behind the worktops, made from the same stone as the worktops but usually in 20mm thickness. Upstands are usually 100mm high, but other heights can be specified.

Splashbacks are stone panels used behind hobs, ranges and sinks. Splashbacks can also be fitted from the top of the worktops to underside of the wall units.
 
Length mm
Height mm
Example
1550
150
Upstand 1
Upstand 2
Upstand 3
Upstand 4
Upstand 5
Upstand 6




Radius & Additional Cuts

On Peninsular or Island Units you can choose to have curved, (radiused), ends. You can also choose to have the corners of your worktops rounded instead of squared off.









Polished Cutouts

These are visible cut outs for under mounted, butler sinks etc that require the inner exposed edges to be polished.







Tap Holes

These are the cutouts for taps and switch holes.







Drainer Grooves

These are straight grooves channelled into the worktop at the side of the sink which act as a draining board. These are normally supplied as a set of five grooves.







Unpolished Cutouts

These are the cutouts with unfinished inner edges that are not visible for surface (over) mounted sinks, hobs etc.







Flush Hobs

These are the recessed cutouts for hobs etc.







Care Kits

A comprehensive care kit containing all you need to care for and maintain your worktops in beautiful condition.






* Mandatory Fields